An additional hole is required if you want to replace the grip of a new LP 10 E (blue electronic) with an older grip:
You can check if your LP 10 is already equipped with the ball bearing trigger by looking at the ball bearing around the bolt above the trigger (fig.). |
![]() |
![]() |
For comparison: the former standard trigger of the LP 10 without ball bearing. |
1. Do not fire the weapon until the air cylinder is totally empty. In this way, pumping does not take as long or require as much effort.
2. After filling, turn the air cylinder one turn. Then open the drainage screw to allow water to drain out of the pump.
It is important that the air cylinder is NOT turned more than one turn, because otherwise the o-ring does not seal perfectly and it does not drain correctly.
3. Retighten the srew.
RESULTS ISSF WORLDCUP, BAKU (AZE) ISSF Worldcup Baku27.05 - 07.06.2022 Air Pistol Women: Bres Klaudia (POL) – EVO 10 E Kostadinova Antoaneta (BUL) – EVO 10 E Air...
Mehr...RESULTS ISSF GRAND PRIX, GRANADA (ESP) ISSF Grand Prix Granada21.05 - 25.05.2022 Air Pistol Woman: Kim Borni (KOR) – EVO 10 E Arunovic Zorana (SRB) – EVO...
Mehr...